General Electrical FundamentalsLesson 1: Build Your First Circuit
Module 1: Understanding Electricity

Lesson 1: Build Your First Circuit

A free beginner lesson on how electrical circuits work: voltage, + and − terminals, loads, and open vs closed circuits, with a hands-on circuit simulator.

  • About 10 minutes
  • 8 questions
  • 1 hands-on activity

In this lesson you’ll learn

  • What electricity is
  • What voltage means
  • Positive and negative terminals
  • What an electrical load is
  • Open and closed circuits
  • Why a circuit must be complete
Lesson summary
  • Electric current is a flow of electric charge.
  • Voltage is the electrical push that drives current, measured in volts (V).
  • A battery has a positive (+) and a negative (−) terminal. Conventional current flows from + round to −.
  • A load, like a bulb, uses electrical energy to do a useful job.
  • A closed circuit lets current flow. An open circuit has a gap, so it doesn’t.
  • Current only flows around a complete loop. A break anywhere stops it everywhere.

Lesson notes: Build Your First Circuit

A written version of this lesson. The hands-on simulators are in the lesson itself.

Electricity is charge on the move

Everything is made of tiny atoms, and atoms contain even tinier particles that carry electric charge.

In a metal wire, some of these charges are free to move. When they all drift the same way, we call that flow an electric current.

Key idea: Electricity in a circuit is simply electric charge flowing along a path.

Voltage is the push

Charges won’t flow on their own; something has to push them. That push is called voltage, measured in volts (V).

A bigger push makes more current flow. Drag the slider to see it.

Key idea: Voltage is electrical push. The workbench battery gives a 12 V push.

Every battery has a + and a − terminal

A terminal is a connection point. A battery has two:

  • + Positive: the high-voltage side, usually marked red.
  • − Negative: the low-voltage side.

Connect a path between them and current flows out of +, around the circuit, and back into −.

Key idea: This + to − direction is called conventional current. (Inside the wire, the tiny charges actually drift the other way, but diagrams always use + to −.)

A load puts electricity to work

A load is anything that uses electrical energy to do a useful job.

In our circuit the bulb is the load: it turns electrical energy into light.

Key idea: Every useful circuit needs a load. Joining + straight to − with no load creates a short circuit, which is dangerous.

Open or closed?

A switch makes or breaks the path:

  • Closed circuit: the switch is closed, the path is complete, and current flows.
  • Open circuit: the switch is open, leaving a gap, so no current flows.

Try it: click the switch.

Current needs a complete loop

Current must travel all the way from +, through the load, and back to −.

The charge isn’t used up; it goes round and round like a bike chain. Break the loop anywhere and the whole flow stops.

Try it: tap any wire to cut it, then tap again to reconnect.

No experience needed. Answer as you go; you can always try again.