Automotive ElectricalLesson 9: Switches, Fuses and Relays
Module 6: Switching and Protection

Lesson 9: Switches, Fuses and Relays

How switches, fuses and relays work: normally open and closed switches, why fuses protect wiring, and a working 4-pin car relay with pins 30, 85, 86 and 87.

  • About 25 minutes
  • 6 questions
  • 2 hands-on activities

Builds on Lesson 8: How to Use a Digital Multimeter

In this lesson you’ll learn

  • How switches control a circuit
  • Normally open versus normally closed
  • What a fuse does and why it protects wiring
  • Choosing the right fuse rating
  • How a relay works
  • Pins 30, 85, 86 and 87 on a four-pin relay
Lesson summary
  • A switch opens or closes a circuit. It is wired in series with the load it controls.
  • Normally open (NO) contacts close when operated; normally closed (NC) contacts open when operated.
  • A fuse is a deliberate weak link: it melts and opens the circuit when the current is too high, protecting the wiring from overheating.
  • A fuse must be rated to protect the wire it feeds. Never fit a bigger fuse, and never bypass one.
  • A relay uses a small control current through its coil to switch a large load current through its contacts.
  • Four-pin relay: 85 and 86 are the coil (control circuit); 30 and 87 are the contacts (load circuit).

Lesson notes: Switches, Fuses and Relays

A written version of this lesson. The hands-on simulators are in the lesson itself.

Switches: open and closed

A switch makes or breaks the path for current. Some stay where you put them; others only change while pressed.

Try each type. Press and hold the push buttons (in the diagram, or with the button).

Key idea: Normally open (NO): off until operated. Normally closed (NC): on until operated. “Normally” means the resting state.

Fuses protect the wiring

Too much current makes a wire hot: enough to melt its insulation and start a fire. A fuse is a thin link, in series, that melts first and opens the circuit.

Create a short circuit and watch the fuse. Then remove the short and replace the fuse.

Key idea: A fuse protects the wiring, not the device. It must be rated at or below what the wire can safely carry. (In this model a fuse blows the instant its rating is exceeded; real fuses take longer on a small overload.)

Relays: a small current switches a big one

A cooling fan can draw 10 A or more. Running that through a dashboard switch would need thick wiring and a heavy switch. Instead, a relay does the heavy switching.

  • Control circuit: a small current flows through the relay’s coil (pins 86 and 85). The coil becomes an electromagnet.
  • Load circuit: the magnet pulls the contacts together, connecting pin 30 to pin 87 and powering the load.

Turn the switch on and compare the two currents.

Key idea: The two circuits are separate. The coil is only an electromagnet; the load current never flows through the switch. (A typical 12 V relay coil is about 80 Ω, so it draws 0.15 A.)

Worked examples

  1. A 12 V relay coil has a resistance of 80 Ω. What control current does the switch carry?

    I = V ÷ RI = 12 V ÷ 80 ΩI = 0.15 A, tiny compared with the 10 A fan current

No experience needed. Answer as you go; you can always try again.