Measurement & TestingLesson 10: Electrical Fault Finding and Troubleshooting
Module 7: Fault Finding

Lesson 10: Electrical Fault Finding and Troubleshooting

Electrical troubleshooting for beginners: a clear fault-finding method, voltage drop testing, and a simulator with hidden faults to find with a multimeter.

  • About 40 minutes
  • 5 questions
  • 1 hands-on activity

Builds on Lesson 9: Switches, Fuses and Relays

In this lesson you’ll learn

  • A systematic fault-finding method
  • Open circuits: broken wires and disconnected parts
  • Short circuits and blown fuses
  • High-resistance connections and poor grounds
  • Voltage drop testing under load
  • Diagnosing hidden faults with a multimeter
Lesson summary
  • Work systematically: confirm the symptom, understand the circuit, test, narrow down, fix, then verify the repair.
  • Open circuit: no current flows, and the full supply voltage appears across the break.
  • Short circuit: current bypasses the load and returns to ground, so the fuse blows. Find it with resistance to ground, power off.
  • High resistance (corrosion, a poor ground, burnt contacts) makes a load dim or slow. Find it with a voltage drop test under load.
  • A good connection or wire drops almost no voltage under load: a few tenths of a volt at most.
  • Resistance and continuity tests only on a de-energised circuit; continuity can pass even when a connection is too poor to carry the load.

Lesson notes: Electrical Fault Finding and Troubleshooting

A written version of this lesson. The hands-on simulators are in the lesson itself.

Fault finding is a method, not guesswork

  1. Confirm the symptom. Does the lamp not work at all, or is it dim? Does a fuse keep blowing?
  2. Understand the circuit. Trace the path from battery +, through the fuse, switch and load, to ground.
  3. Check the simple things. Battery voltage, the fuse, the connectors.
  4. Test, don’t guess. Measure voltages along the path with the circuit on. Where does the voltage disappear?
  5. Narrow it down to one wire, connection or component, then confirm with a second test.
  6. Repair, then verify that the circuit works properly, and ask why it failed.

Key idea: Every measurement should answer a question. Write down what you expected and what you found.

Open circuits: follow the voltage

In this circuit the feed wire is broken between the switch and the lamp. Keep the black probe on battery − (I). Move the red probe along the path: A, B, C, D…

Where does the 12 V disappear? Then put both probes either side of the break (C and D).

Key idea: With an open circuit, no current flows, so there is no voltage drop anywhere except across the gap itself: the full 12 V appears across the break.

High resistance: the voltage drop test

Here the lamp works but is dim: the ground connection is corroded. A resistance test with the power off might look fine, because only a tiny meter current flows.

Instead, test under load (lamp on): put the probes across one part of the path, a wire or connection, and read the volts it wastes. Try G → H (across the ground point), then E → F (across the lamp).

Key idea: A good wire, switch or connection drops almost nothing: a few tenths of a volt at most. Several volts across a connection means high resistance. Every volt lost there is a volt the load doesn’t get.

Short circuits and blown fuses

Here the feed wire’s insulation has rubbed through onto the body. Turn on the switch with a new fuse: it blows straight away.

To find a short, de-energise the circuit and measure resistance from the feed to the body (C → H). Normally you’d see the lamp’s 4 Ω; a short reads close to 0 Ω.

Key idea: A fuse that blows again immediately means a short circuit is still there. Find it before fitting another fuse.

No experience needed. Answer as you go; you can always try again.